Publicidad
Idiomas disponibles
Idiomas disponibles
PLEASE NOTE
Do not dip the pouring spout into the beer in the glass. This can result in a too much
head.
It is normal for there to be more foam than usual when pulling the rst serving of beer.
The last serving may squirt out of the keg at a higher than normal pressure.
3.4 Replacing the beer keg
1.
Push the tap handle into the vertical, shut position.
2.
Turn the dispenser o .
3.
Set the CO pressure regulator to the "O " / "-" position.
4.
Open the beer dispenser cover.
5.
Push the white buttons on the beer riser pipe down to release
the connections.
6.
Remove the keg and riser pipe from the dispenser.
7.
Loosen the right-hand side of the riser pipe rst, then the left-
hand side.
8.
Hold the beer riser pipe in a vertical position when you pull it
out of the dispenser.
9.
After this, follow the instructions in the "Universal 5 litre beer
keg" or "5 litre Heineken beer keg" section.
PLEASE NOTE
Clean the beer riser pipe and the dispenser as described in the "Cleaning and care"
section before you insert a new beer keg.
3.5 Replacing the CO pressure cartridge
The CO pressure cartridge should only be changed if no beer comes out of the tap alt-
hough the CO pressure regulator is turned on and there is enough beer in the keg.
Turn the dispenser o . Set the CO pressure regulator to "–". Open the beer dispenser
cover. Proceed as described in the "How to install the CO pressure cartridge" section.
PLEASE NOTE
When removing the empty CO pressure cartridge, make sure that you do not also
remove or damage the sealing ring or spike.
CO pressure cartridges are not required for 5 litre Heineken kegs.
A 16 gramme CO pressure cartridge may dispense more than 5 litres of beer.
CASO Beer Master
DE
EN
ES
SV
FR
IT
NL
61
Publicidad
