CASO DESIGN Beer Master Manual Del Usuario página 64

DE
4.
Insert a new spike in the CO regulator assembly (the spike must be visible and facing
EN
towards you).
5.
Place the CO sealing ring in the CO regulator assembly.
ES
6. Use an empty CO pressure cartridge or a screwdriver to carefully push both ele-
ments into the assembly.
SV
FR
DANGER
IT

WARNING! Using a full CO pressure cartridge may result in an explosion!
NL
4.5 Replacing the pin seal on the beer riser pipe
If you notice that beer is leaking out of the riser pipe, then you
must replace the seal. Remove the beer riser pipe and tap from the
dispenser. Unscrew the pipe from the tap (anti-clockwise); remove
the old seal and insert a new one. Following this, screw the pipe
back onto the tap (clockwise).
5 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
5.1 Safety notices
ATTENTION

Repairs of electrical appliances must be carried out by quali ed person who are
trained by the manufacturer.

Repairs performed by untrained persons may result in considerable hazards for the
user and damage the machine.
5.2 Troubleshooting table
Error
The tap does not work
/ No beer is coming out
of the dispenser.
64 CASO Beer Master
Possible cause
The beer pouring hose is atta-
ched incorrectly
No beer keg is connected or
there is no beer in the keg.
No gas in the CO pressure
cartridge
Solution
Attach the hose correctly.
Connect a new beer keg.
Replace the cartridge.