Publicidad
Idiomas disponibles
Idiomas disponibles
97001i-P-EU
Cleaning the Air Filter
1. Loosen the four cover screws and remove the maintenance
cover.
2. Locate the air filter plastic cover and remove by pinching the
clips together and pulling the cover off.
3. Remove the foam element.
4. Wash in liquid detergent and water. Squeeze thoroughly dry in
a clean cloth.
5. Saturate in clean engine oil.
6. Squeeze in a clean, absorbent cloth to remove all excess oil.
7. Place the filter in the assembly.
8. Re-install the maintenance cover.
Cleaning the Spark Arrestor
1. Recommended every 50 hours use or annually. Allow the
engine to cool completely before servicing the spark arrestor.
2. Remove the two screws holding the cover plate which retains
the spark arrestor to the muffler.
3. Remove the spark arrestor screen.
4. Carefully remove the carbon deposits from the spark arrestor
screen with a wire brush.
5. Replace the spark arrestor if it is damaged.
6. Position the spark arrestor on the muffler and attach with the
screws removed in step 2.
Failure to clean the spark arrestor regularly will result in
degraded engine performance and may damage engine
resulting is voiding any warranty.
Federal and local laws and administrative requirements
indicate when and where spark arrestors are required. When
ordered, spark arrestors are required for operation of this
generator in National Forest lands. In California, this generator
must not be used on any forest-covered land, brush-covered
land, or grass-covered land unless the engine is equipped with
a spark arrestor.
Adjusting the Governor
Tampering with the factory set governor will void your
warranty.
The air-fuel mixture is not adjustable. Tampering with the governor
can damage your generator and your electrical devices and will
void your warranty.
32
MAINTENANCE
CAUTION
A
NOTICE
WARNING
A
Publicidad
