Roger Technology B70/1DCHP Instrucciones Y Advertencias Para El Instalador página 74

15
Special parameters for BG30/1400/R series
The BG30/R series (REVERSIBLE) is a family of digital brushless motor units for sliding gates weighing up
to 1400 kg and dedicated exclusively to residential and industrial applications.
REVERSIBLE technology makes it possible to open and close the gate without releasing the motor even in
the event of power failure. When the gate is moved manually, in the absence of supply voltage, the rotation
of the motor provides power to the control unit the display lights up and the message '
handle the gate by hand with moderation.
The control unit allows independent management of speed, acceleration, deceleration and the safety devices used in
the system.
impede manual movement of the gate.
As a result, prolonged operation may drain the battery when operating under battery power.
3 cm is detected, the control unit initiates a position recovery procedure (see chapter 21).
NOTE: Even though it is a REVERSIBLE unit, the motor is equipped with a lock release system.
The additional parameters for enabling REVERSIBLE technology are indicated as follows.
Selecting automation system model
WARNING!
The automation system will no longer function effectively and it will not be possible to diagnose faults.
N.B.: in the event of a reset to restore the default parameters, this parameter must be set again manually.
BG30/1600 - IRREVERSIBLE motor for gate leaves up to 1600 kg.
BG30/2200 - IRREVERSIBLE motor for gate leaves up to 2200 kg.
BG30/1000/HS - High Speed IRREVERSIBLE motor for gate leaves up to 1000 kg.
BG30/1400/R - REVERSIBLE motor for gate leaves up to 1400 kg.
BG30/1800/HS - High Speed IRREVERSIBLE motor for gate leaves up to 1800 kg.
BG30/1500/HS - High Speed IRREVERSIBLE motor for gate leaves up to 1500 kg.
Setting deceleration during opening
Setting deceleration during closing
= the gate decelerates near the limit switch ...
Setting start acceleration during opening
Setting start acceleration during closing
= the gate accelerates rapidly at start of manoeuvre ...
manoeuvre.
Setting opening speed
N.B.:
Setting closure speed
N.B.:
= 6 m/min ...
N.B.: to set the constant speed deceleration space, see parameters
74
= maximum speed.
= the gate decelerates long before the limit switch.
= the gate accelerates slowly and progressively at start of
and
' appears. WARNING!
on Chapter 13.