Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
Original parking distance control, Audi A5 Cabriolet and Audi Q5➤
Kit contents:
◆
1 x controller
◆
1 x buzzer
◆
4 x sensor
◆
4 x covering rings
◆
1 x fixing material
Special tools, test and measuring equipment, and ancillaries required:
◆
Flat-bladed screwdriver
◆
Phillips screwdriver
◆
Torx Allen keys (set)
◆
Side cutters
◆
Hand drill
◆
Set of twist drills
Forstner bit ∅ 20
◆
◆
Measuring and cutting tool
Procedure:
Note
◆
The original parking distance control system should be fitted by a competent workshop. Incorrect fitting may lead
to damage to the vehicle or the parking distance control system.
◆
The work to be performed described in these fitting instructions may change due to model servicing schedules.
For example, changes to the wiring colours or even the fitting sites should not be discounted. For this reason,
always consult the relevant up-to-date wiring diagram or the current vehicle repair manual.
◆
All rights to make technical changes reserved.
1.1 Paint sensors
Note
◆
The sensor only require painting in the car colour when the bumpers are painted. In the bumpers are not painted,
the sensors do not require painting.
◆
Do not clean the sensors prior to painting with a silicone remover, but use a mild alcohol, e.g. methylated spirit
◆
Leave the sensors for painting in the packaging supplied, this is provided as a painting device.
◆
Additional painting information:
⇒
Self-study programme No. 214/215
Page 2 - figure 1
The figure gives an example of the protective rings -1- already placed in the correct position on the sensors -4-.
−
Place the covering rings -2- on the rubber membranes of the sensors -3-.
−
Paint the sensors -3- and -4- evenly and not too thickly, in the same colour as the car.
−
Remove covering rings -1- and -2- carefully straight after painting (while the paint is still wet) using tweezers and
let the paint dry.
Note
The protective rings -1- and -2- must be placed on the sensors -3- and -4- before any painting is carried out.
−
Repaint as necessary after drying (e.g. clear lacquer for twin coat painting).
1.2 Mark and drill the sensor fitting holes
−
Switch off all electrical equipment and the ignition, and remove the ignition key from the ignition.
−
Remove the right side luggage compartment trim.
⇒
Interior bodywork fitting; Repair Group 70; trim/padding; trim
24
◆
1 x power harness
◆
1 x sensor harness
◆
1 x installation instructions
◆
1 x operation manual
◆
Pencil
◆
Centre punch
◆
Triangular file
◆
Round file
◆
Tweezers
◆
Scissors
◆
-VAS 1978- wiring harness repair set
8R0 054 630
Publicidad
