CAIRE NewLife Intensity 10 Manual Del Usuario página 24

NewLife Intensity 10
Guidance and Manufacturer's Declaration ± Electromagnetic Immunity
The NewLife is intended for use in the electromagnetic environment specified below. The customer or the user of
the NewLife should assure that it is used in such an environment.
Immunity test IEC 60601 test level
Conducted RF 3 Vrms
IEC 61000-4-6 150 kHz to 80 MHz,
1 KHz or 2 KHz, 80% AM
modulation (6V in ISM
and amateur radio band
in this range for home
environment)
10 V/m
Radiated RF
80 MHz to 2700 MHz,
IEC 61000-4-3
1 KHz 80% modulation
for home environment
NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and
reflection from structures, objects and people.
Note 3: Under some radiated immunity conditions the concentrator may shut down and automatically restart.
Note 4: Under some radiated immunity conditions the concentrator low oxygen concentration warning light may
activate due to interference.
Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land
a
mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted theoretically
with accuracy. To assess the electromagnetic environment due to fixed RF transmitters, an electromagnetic site
survey should be considered. If the measured field strength in the location in which the NewLife Intensity 10 is used
exceeds the applicable RF compliance level above, the NewLife should be observed to verify normal operation. If
abnormal performance is observed, additional measures may be necessary, such as re-orienting or relocating the
NewLife Intensity 10.
Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.
b
24 - ENG PN MN239-C4 F | User Manual
Compliance level
3 Vrms
10 V/m
Electromagnetic environment ±
guidance
Portable and mobile RF communications
equipment should be used no closer to
any part of the Companion 5, including
cables, than the recommended sep-
aration distance calculated from the
equation applicable to the frequency of
the transmitter.
Recommended separation distance
d 1 2 . P

d 1 2 . P
from 80 MHz to 800 MHz

d P
1 2 .
from 800 MHz to 2.5 GHz

where P is the maximum output power
rating of the transmitter in watts (W)
according to the transmitter manufacturer
and d is the recommended separation
distance in meters (m).
Field strengths from fixed RF transmit-
ters, as determined by an electromag-
netic site survey, should be less than
a
the compliance level in each frequency
range.
b
Interference may occur in the vicinity
of equipment marked with the following
symbol: