Publicidad
Idiomas disponibles
Idiomas disponibles
B
Installation
Selection of installation equipment
• Cut out the work surface according to the sizes shown in the drawing.
• For the purpose of installation and use, a minimum of 5 cm space shall be preserved
around the hole.
• Be sure the thickness of the work surface is at least 30 mm. Please select heat-resistant
and insulated work surface material (Wood and similar fibrous or hygroscopic material
shall not be used as work surface material unless impregnated) to avoid the electrical
shock and larger deformation caused by the heat radiation from the hotplate. As shown
below:
NOTE:
The safety distance between the sides of the hob and the
inner surfaces of the worktop should be at least 3 mm.
A(mm)
B(mm)
268+4
500+4
-0
-0
Under any circumstances, make sure the Induction cooker hob is well ventilated and the air
inlet and outlet are not blocked. Ensure the induction cooker hob is in good work state. As
shown below.
Using the appliance
H
C(mm)
D(mm)
50 min.
50 min.
Min.3 mm
E(mm)
F(mm)
50 min.
50 min.
5
EN
SEAL
G
H(mm)
3mm
55
min.
Publicidad
