Columbus McKinnon Yale BatteryStar Manual De Instrucciones página 16

4. Depress and hold the Directional Button DOWN on the front of
the Remote Control and the Pairing Button inside the rear battery
compartment.
5. Release the STOP Button while continuing to hold the Directional
Button DOWN and the Pairing Button for approximately
5 seconds. The Weight Overcapacity Indicator will illuminate
to indicate the operation is successful. Release the Directional
Button DOWN and the Pairing Button.
6. Power the Remote Control on and conduct any required testing.
The electronic load limiter will remain disabled until the STOP
Button is depressed again or the hoist and Remote Control
become disconnected.
7. Prior to returning hoist to service ensure electronic load limiter is
re-enabled and functioning properly.
1 Weight Overcapacity
Indicator
2 STOP Button
HOIST LUBRICATION
NOTE To assure extra-long life and top performance, be sure
to lubricate the various parts of the hoist using the lubricants
specified. If desired, these lubricants may be purchased from
the manufacturer.
GEARS
The gearbox is packed with grease during assembly and should not
need to be replaced unless the gears have been removed from the
housing and degreased. Do not attempt to repair or service the
planetary gearbox.
If the gears are removed from the housing, wipe off the excess
grease with a soft cloth and degrease the gears and housings. Upon
reassembly, add grease to gears and housing.
BEARINGS
All bearings and bushings, except the lower hook thrust bearing,
are pre-lubricated and require no lubrication. The lower hook thrust
bearing should be lubricated at least once a month. Apply a thin film
to both sides of the bearing. Do not allow grease on fastener threads.
BatteryStar
TM
3 Pairing Button
1 Thrust bearing
CHAIN GUIDES AND LIFTWHEEL
When the hoist is disassembled for inspection and/or repair, the
chain guides and liftwheel must be lubricated. The lubricant must be
applied in sufficient quantity to obtain natural runoff and full coverage
of these parts.
LOAD CHAIN
A small amount of lubricant will greatly increase the life of the load
chain. Do not allow the chain to run dry.
Keep the chain clean and lubricate it at regular intervals. Normally,
weekly lubrication and cleaning is satisfactory, but under hot and dirty
conditions, it may be necessary to clean the chain at least once a day
and lubricate it several times between cleanings.
When lubricating the chain, apply sufficient lubricant to obtain natural
runoff and full coverage, especially in the interlink area.
Unknown lubricants can contain hazardous substances.
TO AVOID HEALTH PROBLEMS:
Never use used motor oils as a chain lubricant.
Only use recommended lubricant for the load chain.
EXTERIOR FINISH
The exterior surfaces of this hoist are made of a durable polymer that
requires no maintenance. Exterior surfaces can be cleaned by wiping
with a cloth.
BRAKE CLEANING AND REPLACEMENT
BRAKE CLEANING
To prevent excess buildup of brake dust, follow the procedure below
every 20 hours of operation.
Remove dust caps from the outer housing and use a suitable vacuum
to remove excess brake dust.
NOTE Use a suitable dust extraction device with a minimum
of a HEPA filter and appropriate PPE to avoid exposure to dust
particles.
16
WARNING
P/N: 192097707YLEM June 2024