Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT INSTALLATION
Selection of Installation Equipment
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be preserved around the hole. Be sure the
thickness of the work surface is at least 30mm. Please select heat-resistant and insulated work surface material
(Wood and similar fibrous or hygroscopic material shall not be used as work surface material unless impregnated)
to avoid the electrical shock and larger deformation caused by the heat radiation from the hotplate. As shown
below:
Note: The safety distance between the sides of the hob and the inner surfaces of the worktop should be
at least 3mm.
X
L(mm)
W(mm)
590
520
Under any circumstances, make sure the Induction cooker hob is well ventilated and the air inlet and outlet are
not blocked. Ensure the induction cooker hob is in good work state. As shown below
Note: The safety distance between the hotplate and the cupboard above the hotplate should be at least 760
mm.
D
A(mm)
760 mini
L
H
D
В
X
H(mm)
53
A
B
E E
C
B(mm)
15 mini
W
X
D(mm)
A(mm)
560+1
49
C(mm)
20 mini
11
X
A
Min. 3 mm
B(mm)
X(mm)
480+1
50 mini
wall
D
Air intake
SEAL
F
F(mm)
3 mini
Min.30mm
E
Air exit 2mm
V.1
Publicidad
