Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: Ensuring Adequate Ventilation
Make sure the induction cooker hob is well ventilated and that air inlet and outlet are not blocked. In order to
avoid accidental touch with the overheating bottom of the hob, or getting unexpectable electric shock during
working, it is necessary to put a wooden insert, fixed by screws, at a minimum distance of 15mm from the
bottom of the hob. Follow the requirements below.
There are ventilation holes around outside of the hob. YOU MUST ensure these holes are not blocked
by the worktop when you put the hob into position.
• Be aware that the glue that join the plastic or wooden material to the furniture, has to resist to
temperature not below 150°C, to avoid the unstuck of the paneling.
• The rear wall, adjacent and surrounding surfaces must therefore be able to withstand an temperature of
90°C.
Before Installing the Hob, Make Sure That
• The work surface is square and level, and no structural members interfere with space requirements.
• The work surface is made of a heat-resistant and insulated material.
• If the hob is installed above an oven, the oven has a built-in cooling fan.
• The installation will comply with all clearance requirements and applicable standards and regulations.
• A suitable isolating switch providing full disconnection from the mains power supply is incorporated in the
permanent wiring, mounted and positioned to comply with the local wiring rules and regulations.
• The isolating switch must be of an approved type and provide a 3 mm air gap contact separation in all poles (or in
all active [phase] conductors if the local wiring rules allow for this variation of the requirements).
• The isolating switch will be easily accessible to the customer with the hob installed.
• You consult local building authorities and by-laws if in doubt regarding installation.
• You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall surfaces surrounding the hob.
Before installing onto the workbench, it is necessary to stick the sealing strip onto the back of the glass plate：
• Flip the entire machine over to the back of the glass plate;
• Take out the sponge strip from the self-sealing bag and tear off the double-sided adhesive on the back of the
sponge strip;
• Stick the sponge strip onto
the back of the glass plate.
• The sponge strip should not
exceed the edge of the
glass plate.
Min. 15mm
Max. 5mm
bottom of the product
12
Max. 5mm
spring strip
V.1
Publicidad
