Important - CAMPAGNOLO BORA 2003 FULL CARBON Manual De Uso

- Proceed with inflation of the tubular (follow the instructions on
paragraph 3.2).
- To deflate the tubular, unscrew the valve and press it against the
mechanism inside the adapter.
3.2 - INFLATING AND DEFLATING THE TIRE
• To inflate the tire: remove the cap, unscrew the valve and inflate
using a pump with a pressure gauge to obtain the required pres-
sure, then tighten the valve and re-fit the cap.
• To deflate the tire: remove the cap, slightly unscrew the valve,
then press it until the required pressure is obtained; tighten the
valve and re-fit the cap.
CAUTION!
Never exceed the maximum inflation pressure recommended
by the tire manufacturer.
Note
• The tire pressure should also be adjusted depending on the weight
of the rider; a heavy rider should have a greater tire pressure than
a light rider.
• IMPORTANT: if the inflation pressure is too low, this not only redu-
ces tire performance but also increases the probability of sudden
and unexpected loss of tire pressure. In addition premature wear
and damage to the rim may occur. Excessive tire pressure reduces
6
grip on the road and increases the risk that the tire will unexpec-
tedly burst. These conditions can cause loss of control of the bicy-
cle and an accident.