CAMPAGNOLO BORA 2003 FULL CARBON Manual De Uso página 34

• Slide out the spoke to be replaced (H - Fig. 19) from the hub.
• Insert the new spoke (I - Fig. 20) in the hole in the hub, insert the
plate and retighten the nut.
• Refit the hub, performing disassembly operations in reverse order.
WARNING!
When fitting the wheel, check that the plates remain in position
since an incorrectly positioned plate may caused irreparable
damage to the profile of the rim when tensioning the spokes. This
damage could cause the rim to unexpectedly fail, resulting in an
accident, personal injury or death (Fig. 21).
Attention
When inserting the axle, be careful not to move the ball bearings out
of their seats.
Attention
After completing the operation, check that the flat spoke (aero) is ori-
ented in an aerodynamic position (Fig. 11 - Page 8).
• Following the operations described in Section 5 of the "Owner's
Manual - PART 1":
- Tighten and Settle the Spokes.
- Check centering and wheel dishing.
• After having replaced the spoke and tensioned and centered the
wheel, adjust the hub (see section 7).
19
H
21
20
I
OK! NO!
11