CAMPAGNOLO BORA 2003 FULL CARBON Manual De Uso página 37

• Insert the new spoke in the specific seat in the hub, turning the
longer side (X - Fig. 26) of the cable end (A - Fig. 26) towards the
inside.
• If necessary, reposition the overlapping spoke, making sure that
the overlap is correct where the two meet.
• Slightly closed the spoke retainer ring, then refit it (Fig. 27).
Attention
After completing the operation, check that the flat spoke (aero) is ori-
ented in an aerodynamic position (Fig. 28).
• Following the operations described in Section 5 of the "Owner's
Manual - PART 1":
- Tighten and Settle the Spokes.
- Check centering and wheel dishing.
• After having replaced the spoke and tensioned and centered the
wheel, adjust the hub (see section 7).
14
26
X
A
27
28