Initial Installation; Installing The Casters; Installing The Handles - DJI D12000iEP Guía De Usuario

Initial Installation

Removing the Original Supporting Feet
It is recommended to remove the two original supporting feet near the muffler if the user needs to
move the generator over uneven ground by the handles.
If the user only needs to move the generator on even ground, then it is not necessary to remove the feet.
The specific removal steps are as follows:
a. Place a wooden or rubber block under the generator that is of the same height as the supporting
feet in order to avoid the generator tilting backward when the supporting feet are removed.
b. Remove the bolts and nuts to remove the two supporting feet near the muffler.
1. Bolt
2. Supporting Foot
3. Nut

Installing the Casters

Insert the wheel shaft through the caster, washer, and mounting holes, and secure with a clip.
1. Wheel Shaft
2. Caster
3. Washer
4. Clip

Installing the Handles

Align the handle with the mounting holes on the generator frame, insert the bolt through the mounting
holes, and secure with a clip.
1. Bolt
2. Handle
3. Clip
4
1 2 3
3
1 2
1 2 3
4