Status LEDs
1
2
3
Status LED
Blinking Pattern
Solid yellow
Blinks green once continuously
Charging Channel
Solid green
Status LED
Blinks yellow once continuously
Blinks red once continuously
Blink yellow four times continuously
DC Module Status
Blinks yellow once continuously
LED
Blinks red once continuously
Blink yellow four times continuously
Generator (excl. DC
Blinks yellow once continuously
Module)/AC Module
Status LED
Blinks red once continuously
Blinks red four times continuously
• When the status LEDs blink indicating a warning or error, connect the USB-C connector of
the generator to the USB-A connector of the remote controller using a USB-C cable. Run the
DJI AGRAS™ app on the remote controller and check the specific warnings or errors on the
charging device interface.
• When the status LED blinks prompting for maintenance, connect the USB-C connector of
the generator to the USB-A connector of the remote controller using a USB-C cable. Run the
DJI Agras app on the remote controller and check the specific maintenance information on
the charging device interface. When maintenance is finished, press the reset button on the
charging device interface to turn off the status LED blinking for maintenance.
• If any part of the generator is abnormal or damaged, it is recommended to contact a DJI-
authorized dealer or DJI Support to repair or replace the part.
USB-C Connector on the Generator
1. Charging Channel Status LED
2. DC Module Status LED
4
3. Generator (excl. DC Module)/AC Module Status LED
4. USB-C Connector Cover
USB-C Cable
Description
Battery connected and ready for charging
Charging
Fully charged
Warning for the battery/charging channel
Battery/charging channel error
DC module is not activated
Warning for the DC module
DC module error
Generator (excl. DC Module)/AC Module is not
activated
Warning for the generator (excl. DC Module)/AC
Module
Generator (excl. DC Module)/AC Module error
Generator (excl. DC Module) maintenance is required
USB-A Connector on the Remote
Controller
7