5.
PREPARATIONS FOR USE
EN
5.1. INSTALLATION LOCATION:
1.
Ventilation condition
The position you select for the refrigerator installation should be well-ventilated and has less
hot air. Do not locate the refrigerator near a heat source such as cooker, and avoid it from
direct sunlight, thus guaranteeing the refrigeration effect while saving energy consumption.
Do not locate the refrigerator in the damp place, so as to prevent the refrigerator from rusting
and leaking electricity. The result of the total space of the room in which the refrigerator is
installed being divided by the refrigerant charge amount of the refrigerator shall not be less
than 1m³(space)/8g(refrigerant).
Note: The amount of refrigerant charged for the refrigerator can be found on the nameplate.
2.
Heat dissipation space
When working, the refrigerator gives off heat to surroundings. Therefore, at least 30mm of free
space should be spared at the top side, more than 100mm on both sides, and above 50mm
at the back side of the refrigerator.
Dimensions in mm:
W
D
540
586
Note: Figure 1, Figure 2 only illustrate the space demand of the product.
3.
Level ground
Place the refrigerator on the solid and flat ground (floor) to keep it stable, or else, it will give rise to
vibration and noise. When the refrigerator is placed on such flooring materials as carpet, straw mat,
polyvinyl chloride, the solid backing plates should be applied underneath the refrigerator, so as to
prevent color change due to heat dissipation.
Unobstructed ventilation shall be maintained around the appliance or in an
embedded structure.
5.2. PREPARATIONS FOR USE
1.
Standing time
After the refrigerator is properly installed and well cleaned, do not switch it on immediately.
Make sure to energize the refrigerator after more than 1 hour of standing, to ensure its normal
operation.
2.
Cleaning
Confirm the accessory parts inside the refrigerator and wipe the inside with a soft cloth.
3.
Power-on
Insert the plug into the solid socket to start the compressor. After 1 hour, open the freezer door,
H
A
1920
843
1088
Fig. 1
8
B
C (°)
125±5
Fig. 2
E
F
50
100