Publicidad
Idiomas disponibles
Idiomas disponibles
Platform stacker
Putting into operation
Use of the appliance
43.3000.6
Parts of this section relate exclusively to appliances with heating and do not
apply to unheated models.
Before the appliance is put into operation it must be clean and dry.
Observe the safety instructions from page 22 onwards.
Switch on the appliance
•
Cover stacking well with cover in order to avoid heat losses.
•
Insert appliance plug into a suitable socket with an earth contact.
Only use the plug connection provided for this. The appliance should not
be operated with a damaged connecting lead or other visible damage.
•
Switch on the appliance with the ON/OFF switch.
The indicator integrated in the switch lights up to show that it is ready for
operation.
•
Set the desired power using the regulator. A continous adjustment is pos-
sible within the 4 power ranges.
Depending upon the number and arrangement of the stacks of crockery, the
desired temperature of the crockery with the cover on and an initial crockery
temperature of at least 15 °C will be reached after 3 to 5 hours.
The maximum temperature which can be reached is given in the section
«Technical Data» on page 33.
Insert plates
•
Before the plates are inserted, the guide rods and the stack height must be
set correctly.
•
Insert the plates individually or in small stacks which can be handled safely.
Insert plates:
•
Fill the stacks alternately and more or less uniformly.
•
Place the first plates on the centre of the stacking platform and lower them
slowly.
•
Place the remaining plates precisely onto the plates already positioned in
the appliance.
•
In appliances without covers the maximum filling level is achieved when the
tops of the stacks of crockery are positioned approximately 2 cm above the
upper edge of the appliance.
In appliances with a cover, a higher filling level is possible. Depending upon
the inherent stability of the items, they can be stacked up to the lower edge
of the cover. However, in the model BDUH/60-60/4-S which is heated by
circulating air, the items of crockery above the upper edge of the appli-
cance are not heated to the desired temperature.
Remove plates
•
Remove cover and put it down.
•
Remove plates uniformly from each stack, in order to avoid inclination of
the stacking platform.
•
Put cover back on.
29
Publicidad
