Publicidad
Idiomas disponibles
Idiomas disponibles
Routine Maintenance
EN
Mopping Module
1. Slide the two release clips on the side of the water tank, remove the
mopping module, and pull the mop pad off the mopping module.
2. Pour out the water in the tank. Clean the tank with water only and leave
it to air dry before reinstalling.
Note: Do not directly expose the water tank to sunlight.
18
3. Clean the mop pad with water only and leave it to air dry before reinstalling.
12
11
1
10
2
24 hrs
9
3
8
4
7
5
6
Note: Remove the mop pad from the mopping module before cleaning it,
and make sure dirty water does not flow back into the water outlet to avoid
clogging.
4. If slow water flow occurs, or the water volume is not well-distributed,
clean the air hole in the cover of the water tank.
Routine Maintenance
Main Brush
1. Press the brush guard clips inwards to remove the brush guard and lift
the brush out of the robot.
2. Pull out the brush covers at both ends of the brush as shown in the
diagram. Use the provided cleaning tool to remove any hairs tangled in
the brush. Reinstall the brush covers on both ends of the brush, and then
reinstall the brush. Press on the brush guard to lock it in place.
Side Brush
Remove and clean the side brush.
Omnidirectional Wheel
Note:
·
Use a tool such as a small screwdriver to separate the axle and tire of the
omnidirectional wheel. Do not use excessive force.
·
Rinse the omnidirectional wheel under the running water and put it back
after drying it completely.
EN
19
Publicidad
