Publicidad
Idiomas disponibles
Idiomas disponibles
regulations
• a suitable isolating switch providing full disconnection from the mains power supply is
incorporated in the permanent wiring, mounted and positioned to comply with the local
wiring rules and regulations.
The isolating switch must be of an approved type and provide a 3 mm air gap contact
separation in all poles (or in all active [phase] conductors if the local wiring rules allow for
this variation of the requirements).
• the isolating switch will be easily accessible to the customer with the hobinstalled.
• you consult local building authorities and by-laws if in doubt regarding installation.
• you use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall
surfaces surrounding the hob.
When you have installed the hob, make sure that
• the power supply cable is not accessible through cupboard doors or drawers.
• there is adequate flow of fresh air from outside the cabinetry to the base ofthehob.
• if the hob is installed above a drawer or cupboard space, a thermal protection barrier is
installed below the base of the hob.
• the isolating switch is easily accessible by thecustomer.
Before locating the fixing brackets
The unit should be placed on a stable, smooth surface (use the packaging). Do not apply
force onto the controls protruding from the hob.
Adjusting the bracket position
Fix the hob on the work surface by screw 4 brackets on the bottom case of hob (see
picture) after installation.
Adjust the bracket position to suit for different table top thickness.
-160-
Publicidad
