UNIT INSTALLATION
7 UNIT INSTALLATION
!
C A U T I O N
•
Install the unit in the shade or not exposed to direct sunshine or direct
radiation from high temperature heat source.
•
Make sure that the foundation is flat and sufficiently strong.
•
This unit has aluminum fin with sharp edges. Pay attention to the
fin to avoid injury. Install the unit in a restricted area not accessible
by the general public
•
When installing the outdoor unit in snow-covered areas, mount the
field-supplied hoods at the discharge side of the outdoor unit and
the inlet side of the heat exchanger.
•
Do not install the unit in a space where a seasonal wind directly
blows to the outdoor heat exchanger or a wind from a building
space directly blows to the outdoor fan.
•
In case of installation in the open spaces unavoidably where
there is no buildings or surrounding structures, install near
the wall to avoid facing the wind directly.
Ensure that the service space should be secured.
7.1 INSTALLATION SPACE
Direction of Strong Wind
Direction of Air Discharge
!
D A N G E R
•
Install the unit with sufficient clearance around it for operation
and maintenance. Install the unit where good ventilation is
available.
•
For cleaning, use noninflammable and nontoxic cleaning liquid. Use
of inflammable agent should cause explosion or fire.
•
Work with sufficient ventilation, for working in an enclosed space
should cause oxygen deficiency. Toxic gas should be produced
when cleaning agent is heated to high temperature by e.g., being
exposed to fire.
•
Install the unit in a location where noise emitted by the unit does not
disturb neighbours.
•
Cleaning liquid shall be collected after cleaning.
•
Pay attention not to clamp cables when attaching the service cover to
avoid electric shock or fire.
A Wall to Guard Against Wind
Wall
Secure the adequate
service space.
NOTE:
If the extreme strong wind blows directly against the air
discharge portion, the fan may rotate reversely and be
damaged.
≥
100
9
Direction of Strong Wind
(Unit: mm)
≥
250