Yamaha WR426F Manual De Servcio Del Propietario página 222

È Make sure that the TPS read
coupler does not go outside
the chassis.
Ô Fasten the TPS lead under the
coupler to the frame with a
plastic locking tie.
 Pass the carburetor breather
hoses and overflow
between the connecting rod
and cross tube (frame).
Ò Fasten the neutral switch lead
and oil hose together with a
plastic locking tie and cut off
the tie end.
˜ Fasten
the cylinder
breather hose with the hose
holder.
ˆ Fasten the neutral switch lead
to the frame with a plastic
band ends toward the rear of
the frame.
CABLE ROUTING DIAGRAM
Ø Fasten the neutral switch lead
and CDI
together with a plastic band.
∏ Pass the clutch cable through
the cable guide.
ΠPass
the
breather hose along the inner
hose side of the radiator pipe.
 Pass the clutch cable between
the frame and radiator and
over the lower boss on the
radiator.
Í Pass the neutral switch lead
and CDI magneto lead through
head the cable guide and over the
middle radiator mounting boss.
Then, pass the decompression
cable under the middle radia-
tor mounting boss and along
the left side of the neutral
switch lead and CDI magneto
lead.
magneto lead
cylinder head
2 - 39
SPEC
Ê Pass the clutch cable through
the cable guide.
Ë Fit the brake hose into the
guides on the protector.
◊ Fasten the ignition coil lead
(in the sub wire harness) on
the upper inside of the frame
and cut off the tie end.
„ Pass the ignition coil lead (in
the sub wire harness) under
the cushion bracket (frame).
≈ Fasten the ignition coil lead
(in the sub wire harness) to
the frame with a plastic lock-
ing tie and cut off the tie end.
Á Pass the carburetor breather
hoses, overflow hose and
coolant reservoir
breather hose so that all there
hoses do not contact the rear
shock absorber.
tank