Installation - Mondolfo Ferro MT 3800 LASER Manual De Uso

WARNING
Always unplug the power supply cable from
the socket before moving the machine.
CAUTION
Never apply force to the wheel spin shaft
when moving the machine.

INSTALLATION

WARNING
Carry out the unpacking, assembly and installa-
tion operations indicated below with great care.
Failure to comply with these instructions could
damage the machine and put the operator at risk.
Remove the original packing materials after
positioning them as indicated on the packaging
and keep them intact so that the machine can
be safely shipped at a later date if necessary.
WARNING
The place where the machine is to be installed
must conform to applicable safety at work
regulations.
In particular, the machine must only be in-
stalled and used in protected environments
where there is no risk of dripping onto it.
The floor must be strong enough to support a
load equal to the weight of the equipment plus
the maximum load allowed. The support base on
the floor and the envisaged fixing means must
also be taken into account.
IMPORTANT:
For the correct and safe operation of the
machine, the lighting level in the place of use
should be at least 300 lux.
Environmental operating conditions must comply
with the following requirements:
- Relative humidity ranging from 30% to 80%
(without condensation).
- Temperature ranging from 5° to +40°C.
48
CAUTION
For information concerning the technical fea-
tures, warnings and maintenance instructions
consult the related operator manuals provided
with the documentation of the machine.
WARNING
The machine must not be operated in potentially
explosive atmospheres.
The machine is supplied partially disassembled
and is to be assembled according to the pro-
cedures described below.
LCD monitor and relevant support
assembly instructions
- connect the ground cable and the keyboard
cable, leading out of the weight tray, to the
respective connectors under the monitor
mount (A, fig.5);
- fit the two galvanised spacers in the holes
in the weight carrier cover, then fasten the
monitor mount (A, fig. 5) using the two M8X50
screws and the two M8 washers included (B,
fig. 5);
- Remove the monitor from its packaging and fix
it to the support flange using the four screws
provided with the machine (A, fig. 6).
MT 3800 LASER - Operator's manual
5