Mondolfo Ferro MT 3800 LASER Manual De Uso página 70

19. Perform a spin. When the spin is over the
optimisation programme has been completed
and the weights to be applied to balance the
wheel are displayed.
In case an error compromises the final result,
the machine signals this with the E 6 message.
Now, the procedure can be repeated. The error
message disappears by selecting any of the
available functions.
Special cases
- At the end of the first spin, the message
"OUT 2" may be displayed on the screen.
In this case, it is convenient to exit the pro-
gramme by selecting exit
weight values needed to balance the wheel
will be shown on the monitor. The execution
of the programme is interrupted, thus not
achieving the moderate improvement of
the end results. However, the optimisation
procedure can be run by selecting the OPT
continue procedure icon
- At the end of the second spin, the indication
to invert the tyre mounting on the rim may
be displayed. If you do not want to invert it
or it is impossible to do so, select the disable
tyre inversion icon
will provide the instructions to complete the
programme without inversion.
The Enable tyre inversion icon restores the
inversion function.
- It is possible to exit the optimisation pro-
cedure at any time by simply selecting the
Exit key twice
- If a different working environment is recalled
between one step of the OPT programme
and the next one, the OPT procedure always
remains stored. Therefore, going back to the
start environment, the programme resumes
the execution from the point where it was
interrupted. This situation is possible when
the Temporary Exit icon
70
: the
.
. the machine
.
is selected.
Easy Weight Suite
Easy Weight is a suite containing 4 programmes:
1. Hidden Weight
2. Split Weight
3. OPT Flash
4. Minimum Weight
Note: the Hidden Weight, Split Weight and OPT
Flash programmes are available even when Easy
Weight is not enabled.
To access this suite you must:
• Select the icon Utility programmes.
• Select the icon Easy Weight.
In this way you will access the main screen of
Easy Weight, showing 4 icons:
1. The icon OPT Flash, for the unbalance
minimisation program.
2. The icon Balancing programmes, which
unites all the available balancing pro-
grammes.
3. The icon Statistics, which visualises the
statistics relating to the use of the Minimum
Weight program.
4. The icon Minimum Weight, for the slow or
fast vehicles weight savings programs.
If programme EASY ALU 1 or EASY ALU 2 has
been set to "Auto" mode, the icon Hidden
Weight will also appear, while if the programme
MOTORCYCLE ALU has been set to "motorcycle"
mode, the icon Divide side weight will appear.
Note: for Balancing programmes refer to the
BALANCING PROGRAMMES paragraph.
Note: for the using the OPT Flash programme,
see the paragraph OPTIMISATION PROGRAMME
(OPT FLASH).
Weight savings programme
(Minimum Weight)
This programme allows you to obtain the op-
timum balancing of the wheel, reducing the
quantity of weight to be applied to a minimum.
To access this programme you must:
• Select the icon Utility programmes.
• Select the icon Easy Weight.
In this way you will access the main screen of
Easy Weight, and the unbalance values visualised
will be automatically updated.
Selecting the icon Minimum Weight, it is possible
to choose between 2 different weight savings
programmes:
• Optimised programme for fast vehicle wheels.
• Optimised programme for slow vehicle wheels.
The status bar of the displayed screen will show:
MT 3800 LASER - Operator's manual