Vapor Separator Draining - TOHATSU BFT 60A Manual Del Propietário

Operate the priming valve after
confirming the drain screw is
tightened. When the drain screw is
loose, gasoline will flow out.
5-d. After starting the engine, hold in
the idling position for 3 minutes.
5-e. Drain the gasoline from the
vapor separator.
5-f. Check that there is no water or
any contamination mixed with
the extracted gasoline.
5-g. If there is water or contamination
mixed with the extracted
gasoline, repeat from step 5-a
until there is nothing mixed with
the extracted gasoline.

Vapor Separator Draining

Gasoline is extremely flammable,
and gasoline vapor can explode,
causing serious injury or death. Do
not smoke or allow flames or
sparks in your working area.
KEEP OUT OF REACH OF
CHILDREN.
• Be careful not to spill fuel.
Spilled fuel or fuel vapor may
ignite. If any fuel is spilled, make
sure the area is dry before
storing or transporting the
outboard motor.
• Do not smoke or allow flames or
sparks where fuel is drained or
stored.
STORAGE
VAPOR
TUBE CLAMPER SEPARATOR
DRAIN SCREW
DRAIN TUBE
1. Disconnect the fuel tube assembly
connector (see page 104).
2. Remove the engine cover.
3. Release the drain tube from the
tube clamper of the high pressure
fuel pipe and bring the end of the
drain tube out of the engine under
case.
4. Loosen the vapor separator drain
screw.
5. Tilt up the outboard motor.
133