Tabla de contenido
Publicidad
EN
Fig. 4.2
1
Main fuse 250A used for trucks
2
Main fuse 250A used for (semi-) trailers
3
Exterior control box
4
Hydraulic power pack
5
35 or 50mm² (+) battery cable from main fuse on the
vehicle battery to the incoming pole of the battery
switch of the HTL
6
Incoming pole of the battery switch
7
Incoming pole of the starter solenoid
At the other end of the (+) battery cable, mount the 250A
(or 300A) main fuse as close as possible to the vehicle
batteries. Fit it in a location that is fully protected from
adverse weather conditions. Connect the (+) battery cable
coming from the power pack of the HTL to the main fuse,
and link the main fuse to the (+) battery pole. [See Fig. 4.1
-4.2]
Tighten all electric connections thoroughly.
Take special care of the locking nuts of the
fuses.
Loose & insufficient fitting can lead to bad con-
tact and overheating of the fuse, followed by
premature failing of the power circuit.
Apply a thick layer of anti-corrosive grease or
Vaseline to all electric connections. [See Fig.
1.3]
In case of battery charging systems, follow the
fitting instructions and electric wiring diagrams
of the vehicle manufacturer regarding the wiring
and fuses.
DHOLLANDIA
4.2
1
2
17
3
5
6
7
4
Publicidad
Tabla de contenido
