Rear Wheel Axle Nut Adjustment; Wheel Locks - Sunrise Medical Quickie 2,2 HD Manual De Instrucciones

E NG LIS H
3. Wheel Base Width Adjustment
Adjusting the wheelbase width allows the rider the option to move the wheels closer or further away from the
hips. It also compensates for camber adjustment and gives the proper wheel spacing to maximize pushing efficiency.
4. Adjust the wheelbase width
a. Loosen the nuts and reposition the axle sleeve (A) to the desired width.
b. Retighten nuts.
32
5. Seat Height Adjustment
Seat height can be adjusted by moving the axle plate vertically in the predrilled frame holes (B). This adjustment
allows a 3.375" vertical seat height adjustment.
NOTE– A front caster adjustment should be made to correspond with any change in seat height.
E. REAR WHEEL AXLE NUT ADJUSTMENT
Tight axle sleeves should be maintained for proper performance of the wheelchair.
a. To adjust the axle (C) you will need a 3/4" wrench to turn the outside axle nuts (E).
b. You will also need a 1/2" wrench to lodge the ball bearings (D), on the opposite end of the axle, and prevent
the axle from turning.
c. Turn the outside axle nut (F) clockwise to tighten.
d. There should only be zero to ten thousandths of an inch (.010") of play.
F. WHEEL LOCKS
The Quickie 2 wheelchair is shipped with one of four types of wheel locks. Wheel locks are installed at the factory
unless you have requested otherwise.
Use a torque setting of 144 in.-lbs. when setting up wheel locks.
1. High-Mount Push-to-Lock or Pull-to-Lock
a. Using a 3/16 inch hex key, turn one of the screws (F) in the clamp counterclockwise one-quarter turn.
b. Repeat the same process with the second of the two screws.
c. Alternately loosen the screws (two turns each) until both screws are removed.
d. Slide clamp toward the rear wheel until the wheel lock is embedded into the tire to prevent wheel move-
ment, when in the locked position.
e. Tighten screws to 115 in-lbs.
2. Ergo Scissor Wheel Locks
Loosen the screws (G) on the top of each clamp using a 3/16 inch hex key. Slide assembly toward rear wheel until
clamp embeds into tire to prevent wheel movement when in locked position. Adjust angle position. Tighten screws to
115 in-lbs.
NOTE– Clamp and wheel lock may need to be rotated to clear frame tubing.
31
33
34
, Wheel Locks Adjustment
35
or Compact Wheel Locks
IX. DEALER SERVICE AND ADJUSTMENT
21
31
32
33
34
35
MK-100070 RevA