Padded Swing-Away Armrests; N.SWing-In, Swing-Out Hangers And Footrests; O.ANgle Adjustable Footplates - Sunrise Medical Quickie 2,2 HD Manual De Instrucciones

E NG LIS H
L. PADDED SWING-AWAY ARMRESTS
Swing-away armrests can be detached or can swing away to allow lateral transfers. They are height adjustable
(1" increments) by moving hardware (A) up or down in predrilled holes on armrest bracket.
Additional height can be achieved by removing bolts (B), flipping and rotating the hardware to opposite (C).
Ensure bolts (B) are retightend.
Swing-away, removable armrests are installed by sliding armrest (D) into receiver (C) on back frame.
M. SWING-IN/SWING-OUT HANGERS AND FOOTRESTS
(70º, 80°)
47
1. Height Adjustment
NOTE–
It is recommended that you maintain a minimum of 2.0 inches between the lowest point on the
footrest and the floor.
a. Loosen set screw (E) using a 3/16 inch hex key.
b. Slide footrest extension up or down inside frame tube to desired height.
c. Tighten set screw. Use a torque setting of 144 in-lbs (16.27 Nm).
N. ANGLE ADJUSTABLE FOOTPLATES
1. Composite Angle Adjustable Footplates
a. Remove bolt (F)
b. Pull footplate section (G) away from extension.
c. Reposition footplate back onto extension in new angular position. Use premarked extension
coupling (H) as guide.
2. Aluminum Angle Adjustable Footplate
a. Loosen bolts (G).
b. Adjust footplate (F) to desired angular position.
c. Re-tighten hardware (G).
O. PLATFORM FLIP-UP FOOTPLATES
1. Height adjustment
a. Remove hardware (K)
b. Adjust the footplate assembly (L) up or down to desired height.
NOTE – Footplate must have at least 2inches of clearance between the footplate and the ground to prevent
hitting obstacles and risking a fall or tip-over.
c. Re-tighten the hardware
MK-100070 RevA
46
48
49
50
24
IX. DEALER SERVICE AND ADJUSTMENT
46
47
48
49
50