Armrest Receiver Attachment; Adjustable Locking Flip-Up Armrests - Sunrise Medical Quickie 2,2 HD Manual De Instrucciones

E NG LIS H
J. ARMREST RECEIVER ATTACHMENT
Mounting
1. Place the two clamp receivers (A) over the top portion of the rear side frame tube .Align with the sin-
gle post height-adjustable armrest.
2. Pinch both clamp receivers together at the armpost receiver side and insert into the armpost receiver
.
3. Once inserted, pinch both clamp receivers together on the far side of the armpost receiver.
4. Hold both clamp receivers against the top portion of the rear side frame tube and fasten(C) .
Adjustment
1. To adjust the fit of the Single Post Armrest in the receiver, loosen the 4 hex bolts (D) by using a 7/16"
wrench .
2. With the armrest assembly in the receiver (B), press firmly on the outside of the receiver.
3. Maintain pressure on the receiver and re-tighten two of the hex bolts (D).
4. Remove the armrest assembly and re-tighten the remaining two hex bolts.
5. The armrest will fit firmly in the receiver and lessen any noise that may result from vibration.
K. ADJUSTABLE-LOCKING FLIP-UP ARMRESTS
(optional with depth-adjustable back only)
1. Adjustment
a. Loosen clamp bolts (E).
b. Move clamp up or down backrest posts to desired position.
c. Tighten bolts.
2. Angle-Adjustment
a. Loosen bolt (G).
b. Set armrest at desired angle using preset holes in armrest angle plate (F).
c. Tighten bolt.
41 42 43 44
45
23
IX. DEALER SERVICE AND ADJUSTMENT
41
42
43
44
45
MK-100070 RevA