Oven-user communication
Warning messages (attention) panel control board:
Display message
Non basic control board
WD10
setting error
Alarm messages:
When a condition arises which prevents the appliance from operating at all, an ALARM signal is displayed and
the appliance must be switched to its STOP status.
The device stops operating and the ALARM! message appears on the oven display until the problem is resolved.
If the device is operating when the ALARM status occurs, it will shut down and the alert corresponding to the
detected problem will be displayed.
To resolve a problem of this type, contact an Authorised Assistance Centre.
Once the problem has been resolved, the appliance can be reactivated by pressing the "START/STOP"
button.
If any other devices/accessories are connected to the oven, these will continue to operate normally unless the
alarm corresponds to a specific device that prevents its continued operation.
Alarm messages oven:
Display message
AF01
The motors have overheated
The safety thermostat has
AF02
overheated
An error has been detected
AF03
in the data recorded by both
cavity probes
Communication between the
AF04
control P .C.B. and the power
P .C.B. has been cut off
Communication between the gas
AF05
P .C.B and the power P .C.B. has
been cut off
Gas oven exhaust fumes reach too
AF06
high temperature
AF10
Power card settings error
There is no flame in the
GAS
burner
N.B.
Every time the oven is started electrically, and every time the control P .C.B. exits STANDBY mode, the control
P .C.B. is scanned for ALARM / WARNING conditions (which appear on the display, if present).
Description
The oven keeps on working (with
some limitations due to the setting
involved on the error)
Description
Oven shutdown
Oven shutdown
Oven shutdown
Oven shutdown
Oven shutdown
Oven shutdown
Oven shutdown
The burner is deactivated. Ignition
may be attempted again by ressing
the "START/STOP" button
29
ChefTop
™
Effect
Contact the Customer
Assistance Service
Effect
Contact the Customer Assistance Service
Contact the Customer Assistance Service
Contact the Customer Assistance Service
Contact the Customer Assistance Service
Contact the Customer Assistance Service
Contact the Customer Assistance Service
Contact the Customer Assistance Service
In case it is not possible to re-start the oven,
immediately close the gas cock
BakerTop
Problem solution
Problem solution
English
™