Directives And Manufacturer's Declaration; Electromagnetic Environment - Ottobock Myo Plus Instrucciones De Uso

Compliance with the requirements under "FCC Part 15" (USA)
Non-ionising radiation
Compliance with the requirements under the "Radiocommunications Act" (AUS)
Lot number
Article number
Bluetooth ID number

11.4 Directives and manufacturer's declaration

11.4.1 Electromagnetic environment

This product is designed for operation in the following electromagnetic environments:
• Operation in a professional healthcare facility (e.g. hospital, etc.)
• Operation in areas of home healthcare (e.g. use at home, use outdoors)
The customer or user of the product must ensure that it is operated in such an environment.
Observe the safety notices in the section "Information on proximity to certain areas" (Information
on Proximity to Certain Areas).
The following tables outline the test levels of the tests to be carried out. The higher value applies if
there is a difference between the operating environments listed in the tables below.
Table 1 – Electromagnetic emissions for all devices and systems
Interference measurements
HF emissions according to
CISPR 11
HF emissions according to
CISPR 11
Harmonics according to
IEC 61000-3-2
Voltage fluctuations/flicker
according to IEC 61000-3-3
28
Compliance
Group 1
Class B
N/A
N/A
Electromagnetic environ­
ment directive
The product uses HF energy
exclusively for its internal func­
tioning. Its HF emissions are
therefore very low, and inter­
ference with neighbouring
electronic devices is unlikely.
The product is intended for
use in other than residential
facilities and in facilities con­
nected directly to a public low-
voltage network that also sup­
plies residential buildings.