Filter Replacement; Servicing; Technical Information; Symbol Definitions - F&P Airvo2 Manual Del Usuario

FILTER REPLACEMENT

After the AIRVO 2 has been switched on for 1000 hours, a prompt will appear at the start of the next
disinfection cycle indicating that an air filter change is due. Follow the steps below if filter change is due:
Air filter change
due
Replace now?
Now
Later

SERVICING

This device contains no internal serviceable parts.
Refer to the AIRVO 2 Technical Manual for a list of external spare parts.

5. TECHNICAL INFORMATION

SYMBOL DEFINITIONS

For safety reasons, refer to the
instructions for use
Caution
Consult instructions for use
Warning, hot surface
Manufacturer
Date of manufacture
Date of shelf life expiry
Type BF applied part
(USA) Federal Law restricts this
device to sale by, or on the order
of a physician.
Alarm symbol
Alarm pause
1. Take the filter holder from the back of the unit and remove the filter.
2. Replace the old filter with a new filter (900PT913).
3. Reattach the filter holder to the unit (clip the bottom of the filter
holder in first, then rotate it upwards until the top clips into place).
4. Press the Mode button to move on to the "Replace now" screen.
5. Press the Up button to select "Now".
6. Press the Mode button to confirm.
The hours counter will be reset to zero.
If you choose the "Later" option, the prompt will continue to appear at
the start of subsequent disinfection cycles.
A – 13
Class II equipment
Catalogue number
Serial number
Batch code
Humidity range
Temperature range
Protected against ingress of small objects
and water drops
EU representative
CE Mark
Power on/off (standby)
Regulatory Compliance Mark (RCM)