Turbo CREO SL Manual De Usuario página 29

Fig.10.5: Align the cartridge so that the arrow on the rubber boot aligns with one of the three flat surfaces. The
„
flat surface and arrow must face toward the front of the bike.
Fig.10.6: Torque the steerer tube collar to 35 in-lbf / 4.0 Nm.
„
WARNING! When the cartridge is installed, ensure that the steerer tube collar bolt is greased and
torqued to specification. Do not tighten the collar without the cartridge installed. An improperly
installed and/or tightened collar may cause you to lose control and fall.
Install a stem shim (K) on the cartridge. Use a thick shim for a standard 1 1/8" stem, or a thin shim for the SW
„
Future Stem. The shim must align with the stem toward the back of the bike.
Fig.10.6 (adjustable Future Shock only): The adjuster dial must be removed before the stem is installed.
„
Loosen the set screw on the side of the adjuster knob to remove it. To re-install, align the adjuster dial set screw
with the flat surface (Fig.5 L) on the top of the Future Shock. Torque the set screw to 18 in-lbf / 2.0 Nm.
The SW Future Stems is compatible with all Future Shocks.
The Accessory Mount (S189900104) is compatible with the SL faceplate (S199900064) or the
SW Future Stem.
The SL faceplate is only compatible with the SW Future Stems and SL stems.
10.7
ALIGN SHIM SLOT
WITH STEM SLOT AND
FRONT WHEEL
SHIM
Fig.10.7: Install the stem on the cartridge, then align the stem with the front wheel. Torque the stem according to the
„
manufacturer specifications. Install the handlebar and brakes according to the brake manufacturer's instructions.
NON-ADJUSTABLE FUTURE SHOCK: Install the top cap (fig.10.10-A, finger tight).
„
10.8
2.5 mm
2 mm
3 mm
27
FORK STEM
N
M
RUBBER BOOT
COLLAR
HEADSET COVER
STEERER TUBE
HEAD TUBE
3. TIGHTEN
1. LOOSEN
2. ADJUST