Status Display / Error Messages - Herth+Buss eBlow Instrucciones De Operación

Operating Instruction

5.2 Status Display / Error Messages

Display on IC-CPD
Status
A*
B*
C*
D*
E*
Fault in home installati-
on (miswired)
RCD triggered
Relay is welded. Relay
welding detection error
Overheating
Critical overheat
Internal fault
* The letters describe the charging status of
the electric vehicle.
25
House Power
off off
off off
off
off off
All seven LEDs flash quickly (at 2Hz)
(flash
green at
0.7Hz)
(5 LEDs)
off
95960021 | -022 | -023
Car Remarks
off No vehicle connected
Vehicle connected
Vehicle can be charged
Vehicle with gassing
lead batteries
(after three
seconds)
Short circuit between
CP and PE
off No PE (ground conductor)
present or fault in the home
installation
There is current leakage
(Flashing)
Device is damaged and
must be repaired by the
manufacturer.
off No vehicle connected.
Temperature above 55 °C
Vehicle connected Tempe-
rature above 55 °C. Vehicle
is charged with a reduced
current of 6A.
off Temperature above
65 °C. Vehicle is no
longer charged.
off Internal fault:
Temperature sensor,
memory error, RCD test
negative, temperature is
less than -32 °C