Enabling The Other Operator - Corghi CompactLine EM 9250 Manual De Uso

Press the key to exit or the
- The following message could be displayed at the end of the first spin:
In this case it is advisable to exit the programme by pressing the key:
of the weights necessary for balancing the wheel are displayed. The programme execu-
tion is interrupted, thus not achieving the moderate improvement of the end results. By
pressing the
- At the end of the first spin the instruction that the tyre is to be mounted on the rim in
the reverse direction may appear. If you do not intend to reverse the tyre or if doing so
is impossible, press the
completing the programme without reversing the tyre.

13. ENABLING THE OTHER OPERATOR

This programme makes it possible for two different operators to use the machine at the
same time due to the presence of two different working environments.
The parameters which remain saved for every working environment are:
- balancing mode (Dynamic, Alu x, Motorcycle etc.);
- wheel dimensions (distance, diameter and width of those relating to the active ALU
programme).
The machine's general settings remain the same for all working environments:
- grams/ounces, sensitivity x1/x5, threshold, etc....
Proceed as follows to recall this programme:
• press the
- use the
• press the
1 first operator
or 2 second operator
EM 9250 CompactLine Operator's manual
Out
key the optimisation procedure can be continued.
key and the machine will provide the instructions for
key
keys to search for OPE 1 (or OPE 2 if previously set)
key to change the setting:
key to stay in the programme.
2
the values
UK
101