Spin Counter; General Configurations - Set Up - Corghi CompactLine EM 9250 Manual De Uso

- press the
Activation of the second operator is indicated by the illumination of the LED
display panel.
Repeat the procedure described above to return to the first operator.
14. WHEEL SPIN COUNTER
This programme is used to display the total number of spins performed by the machine since its
first start-up (tot SPi), the number of spins performed since the last unbalance calibration (CAL
SPi) and the number of partial spins performed since the machine was last started (PAr SPi).
Proceed as follows to recall this programme:
• press the
• use the
• press the
its first start-up (tot SPi)
• press the
calibration (CAL SPi). It is reset at each new calibration
• press the
calibration (PAr SPi). It is reset each time it is turned off
• press the

15. GENERAL CONFIGURATIONS - SET UP

The machine can be configured according to your requirements. The following configurations
are available:
- Selecting vehicle type (car – motorcycle)
- Selecting the mode for acquiring wheel dimensions in the ALU1 and ALU2 balancing
programmes (ONLY the version with manual sensor)
- Unbalance unit of measurement
102
key to confirm and exit.
key
keys to search for -SP in-
key to display the total number of spins performed by the machine since
key to display the number of spins performed since the last sensitivity
key to display the number of spins performed since the last sensitivity
key to exit.
EM 9250 CompactLine Operator's manual
on the