Other Messages - Corghi CompactLine EM 9250 Manual De Uso

- This message indicates the valve of the wheel that must be brought to
OP.1
- This message indicates that the position of the valve must be moved
OP.2 180
- This message is displayed when the improvement obtained by optimi-
Out 2
- Press the
- Notice PREMATURE EXIT from the unbalance optimisation program.
Abo rt
- Press the
- Notice TYRE MOUNTING INVERSION ON THE RIM in the OP.5 phase
--I- -I--
- This message indicates that the operator is in the "positioning the weights
HId dEn
no no
- This message is displayed if the wheel is balanced on the outer side.
- This message indicates that the machine is set for acquiring the P1 posi-
in -1-
- This message indicates that the machine is set for acquiring the P2 posi-
in -2-
- This message is displayed for approx. 3 seconds if the selected angle is
no -2-
- This message indicates the reference for acquiring the two points P1 and
in H.X
CAL GO
- Calibration spin.
- This message indicates the correct position for applying the calibration
I - - CAL
116

19. OTHER MESSAGES

the 12 o'clock position during phases 1 and 5 of optimisation (OPt).
180° with respect to the previous position (12 o'clock).
sation is not sufficient.
key to exit the program or the
the optimisation phase.
key to confirm or the
programme.
of the programme.
If you do not want to (or cannot) carry out this operation, press the
key. the machine will provide the instructions to complete
the programme without inversion.
behind the spokes Hidden Weight" programme.
tion behind the first spoke
tion behind the second spoke.
greater than 120 degrees, indicating that the procedure must be repeated
correctly.
P2 behind the spokes. Depending on the configuration performed by
the operator, the message on the display can be H3, H6 or H12. If the
laser indicator is enabled, the reference will be 6 o'clock (H.6).
weight in the unbalance calibration programme at the end of the first
spin.
EM 9250 CompactLine Operator's manual
key to continue
key to remain in the