Entering Wheel Dimensions In Balancing Programmes Alu1P Or Alu2P - Corghi CompactLine EM 9250 Manual De Uso

- modify the displayed diameter value by pressing the
read number is set
- press the
data entry (-A-)
- bring the distance measuring arm into contact with the inner side of the rim (Fig.11)
- read the distance value between the wheel and the body on the rule (A, Fig.13)
- modify the displayed distance value by pressing the
read number is set
- on completion, press
of the new dimensions, or
WARNING
If the diameter and distance values between the two balancing planes, recalculated
on a statistical basis starting from the rated geometric data of the wheel, exceed the
normally accepted interval stated in the technical data section, the message "A 5" is
displayed.
4. ENTERING WHEEL DIMENSIONS IN
THE ALU1P OR ALU2P BALANCING
With this programme the real wheel data have to be set in relation to the real balancing
planes rather than the nominal values (as in standard ALU programmes). The balanc-
ing planes where the adhesive weights are to be applied may be selected by the user
according to the specific shape of the rim. It should be remembered, however, that in
order to reduce the quantity of the weight that is to be applied it is preferable to select
balancing planes that are as far apart as possible: if the distance between the two planes
is less than 37 mm (1.5"), the "A 5" message is displayed.
The various methods for inserting dimensions are described below based on the sup-
plied devices:
88
key to confirm the previous value and set the machine for distance
to display the unbalance values recalculated on the basis
to perform a wheel spin.
PROGRAMMES
EM 9250 CompactLine Operator's manual
keys until the
keys until the