Set Up - Adhesive Weight Application Position; (H3-H6-H12) - Corghi CompactLine EM 9250 Manual De Uso

15.10. SET UP - ADHESIVE WEIGHT
APPLICATION POSITION
The machine makes it possible for the operator to select where the adhesive weight should
be applied based on his needs. To select this configuration, proceed as described below:
- press the
- use the
- press the
- use the
LASER line if present)
- press the
TYPE OF WEIGHT
TO BE APPLIED
Traditional clip
Adhesive
MOTORCYCLE
programme
Adhesive
Adhesive
Adhesive
- press the
110
key
keys to search for SEt UP
key to confirm
keys to search for ALU H.12 (ALU CLP – ALU H.6 using the
key to change the setting:
CONFIGURATION
SELECTED
H.12
LAS
(if applicable)
CLP
key to confirm and exit.
WEIGHT APPLICATION POSITION
Always 12 o'clock
Always 12 o'clock
12 o'clock in all balancing programmes
6 o'clock using the LASER line when the
adhesive weight is inside the rim
12 o'clock when the adhesive weight is
outside the rim
using the weight-holder terminal in the
ALU1P/ALU2P balancing programmes or
manually, using the centre of the notch in
the holder as the reference for the centre
line of the weight, whereas in the statistic
ALU programs, 12 o'clock
EM 9250 CompactLine Operator's manual