Installing A Static Warning Unit - Linde Safety Guard Manual Del Usuario

4
Operation
Installation

Installing a static warning unit

The static warning unit is mounted at points
that are difficult to see and thus allows the
early detection of approaching industrial
trucks.
NOTE
Position the static warning unit so that the
LED display is easy to see.
Installation via magnet
The static warning unit can be mounted to
metal surfaces using a magnet.
 Mount a self-adhesive magnet with the
sticky side on the rear of the housing.
 Attach the static warning unit in the inten-
ded location.
 Connect the static warning unit to the 230-V
power supply.
The static warning unit starts and the operat-
ing status LED flashes green.
Installation via screw joint
 To expose the fixing points, open the hous-
ing panels(1) at the sides.
 Mark the four fixing points on the ground.
 Drill mounting holes and then insert dowels
if these are required.
 Mount the static warning unit with four
screws and close the housing panels.
 Connect the static warning unit to the 230-V
power supply.
The static warning unit starts and the operat-
ing status LED flashes green.
38


Operating Instructions - 3008011701 EN - 11/2019
LSG_0017
1
2
LSG_0019