Maintenance - Linde Safety Guard Manual Del Usuario

5
Maintenance and disposal

Maintenance

Maintenance
CAUTION
Risk of surface damage from using incorrect cleaning
materials.
 Do not use aggressive cleaning materials.
 Do not use cleaning materials containing abrasive
particles
Regularly cleaning the components of the
Linde Safety Guard increases the service life
of the system. After daily use, perform the fol-
lowing steps:
 Check the display units, the sensors and
the warning units for contamination.
 Remove coarse dirt with a soft brush.
 Remove fine dust and film with a damp
cloth.
CAUTION
Lithium-ion battery destroyed as a result of deep dis-
charge.
Do not store the Safety Guard portable warning unit
for more than one year. Charge the portable warning
unit after one year.
Cleaning the active warning vest
CAUTION
Components can be destroyed by moisture.
 Remove the power bank and mobile warning unit
before washing.
64
NOTE
The LED light strip on the warning vest cannot
be replaced. If the LED light strip has reached
the end of its service life, the warning vest
must be replaced.
The average service life of the LED light strip
is 2000 hours or 20 wash cycles. The initial
light output can drop to 50% over the average
service life. The reduction in the light output
depends on the use and the cleaning proce-
dure, which impairs the ability of the light con-
ductor to emit light.
When cleaning the interactive warning vest,
follow the instructions below:
Wash at maximum 60°C
Do not bleach
Do not dry in a rotary dryer
Do not iron
P Clean with perchloroethylene
Remove electrical components before
cleaning
Operating Instructions - 3008011701 EN - 11/2019