Polaris Sportsman 450 HO Manual Del Propietário página 120

MAINTENANCE
Lights
High Beam Adjustment
4. Start the engine.Turn the headlight switch to high beam.
5. Observe the headlight aim on the wall. The most intense part of the
headlight beam should be 5 cm below the mark on the wall.
6. 570 Premium: The adjustment
screw is located on the right side
of the headlight pod. To adjust
the beam, loosen the screw.
Adjust the headlamp to the
desired position, then tighten the
screw.
7. 570/570 EPS/570 X2: The
adjustment knob is located on
the right side of the headlight
pod. Adjust the beam to the
desired position by turning the
knob either clockwise or
counter-clockwise.
8. All Models: Tighten or loosen
the three (3) headlight screws to
adjust the beam.
Low Beam Adjustment
The low beam can be adjusted slightly
upward or downward.
1. Loosen the Phillips screw located
at the rear of the headlamp.
2. Tilt the headlamp upward or
downward.
3. Tighten the screw.
120
570 Premium
Adjustment Screw
Screws
Phillips
Screw