E N G L I S H
U. TRAVEL WHEELS
1. Removing Travel Wheels from Receivers
a. Remove the quick-release pin (A).
b. Remove the travel wheel (B) from the receiver (C).
c. Repeat for other side.
2. Inserting Travel Wheels into Receivers
a. Insert the travel wheel (B) into the receiver (C).
b. Align holes at position for corresponding rear wheel size.
c. Insert the quick-release pin (A) fully.
d. Repeat for other side. Both travel wheels must be set at the same height.
3. Adjusting Travel Wheels for Frame Angle
The travel wheel bracket (D) alignment may need to be adjusted depending upon the angle
of the frame's seat rail. The travel wheel brackets have two hole patterns that offer 2 "Trail"
positions
42
. To adjust the mounting configuration:
a. Remove the 2 mounting screws (E).
b. Rotate the travel wheel bracket (D) to the hole pattern that creates the smallest "Trail"
dimension. Always keep the travel wheel behind the axle centerline.
c. Replace the 2 mounting screws (E), and torque to 106 in-lbs. (12 Nm).
d. Repeat for other side. Both travel wheels must be set at the same angle.
NOTE–
When the wheelchair is configured with the travel wheel and anti-tip options, the travel wheel brack-
et (D) is installed between the camber tube clamp (F) and anti tip receiver bracket (not shown).
V. CHECK-OUT
After the wheelchair is assembled and adjusted, it should roll smoothly and easily. All acces-
sories should also perform smoothly. If you have any problems, follow these procedures:
a. Review assembly and adjustment sections to make sure chair was properly prepared.
b. Review trouble shooting guide.
c. If your problem persists, contact your authorized supplier. If you still have a problem
after contacting your authorized supplier, contact Sunrise customer service. See the
introduction page for details on how to contact your authorized supplier or Sunrise
customer service.
109880 Rev. B
42
43
42
42
42
43
22
42
A
C
B
trail
43
F
D
E
IX.