Publicidad
Figure - 02 ( avec plaque de pré coupage )
06
07
08
01. Corps de la Tête de Hachage
02. Rondelle de Fibre
03. Vis de Déplacement
04. Cheville de la Vis de Déplacement
05. Plaque de pré coupage
3.3
Nettoyage
3.3.1
Détachez l' Interrupteur , et enlevez la fléche de sa prise .
3.3.2
Retirez le Volant No.08 (Fig.02) et tous les composants internes de la
Tête de Hachage .
3.3.3 Pour enlever la Tête de Hachage No.01(Fig.01) desserrez le manipule qui
se trouve sur le coté de la machine , et tenez la tête en la bougeant tours à tours de
coté et en avant .
3.3.4 Lavez tous les composants avec de l' eau chaude et du savon neutre.
3.3.5 Pour remonter la Tête de Hachage , suivez en inverse le procedé au-
dessus.
Ne pas ranger la Tête de Hachage avec du produit enfermé dedans .
29
09
06. Couteau à double face
07. Plaque
08. Volant
09. Ring
IMPORTANT
3.2 Starting
01
Always switch the machine OFF before removing the Head. The machine is
02
silent. Do not leave utensils such as: knives, forks and similar on the Pan.
03
Be sure that the Head's internal components are assembled correctly as
per order indicated on Picture - 03.
04
Pushing the ON/OFF Switch Nº03 (Pic.02) to ON position located on the
05
Motor Housing right hand side activates the machine.
3.3 Cleaning
To do cleaning proceed as follows:
3.3.1
source.
3.3.2
components.
3.3.3
to be able to remove the Head Nº01 (Pic.02).
3.3.4
3.3.5
4. General Safety Practices
If any item from the GENERAL SAFETY NOTIONS section is not applicable to
The following safety instructions are addressed to both the operator of the
machine as well as the person in charge of maintenance. The machine has to be
delivered to the operator in perfect conditions of use by the Distributor to the user. The
user shall operate the machine only after being well acquainted with the safety
procedures described in the present manual. READ THIS MANUAL WITH
ATTENTION.
IMPORTANT
Switch the machine off and unplug the machine from power supply
Remove the Locking Ring Nº06 (Pic.02) and all the Head's internal
Loosen locking knob located on the right hand side of the machine
Wash all components with warm water and neutral soap.
To assemble the Head follow the above sequence inversely.
IMPORTANT
Do not store the Head with product inside.
IMPORTANT
your product, please disregard it.
06
Publicidad
Capítulos
