SRAM Rock Shox Reverb Bleed Kit Manual Del Usuario página 11

Reverb Bleed Kit User Manual
11 iNsTAll THe HOse TO THe ReMOTe AsseMBly
Hold the hose stationary, then thread the remote
assembly onto the hose by hand until it stops. Use
a torque wrench with a 6 mm crowfoot socket to
tighten the remote hose barb to 2.9-3.4 N∙m
(26-30 in-lb).
12
iNsTAll THe ReMOTe AsseMBly TO THe HANDleBAR
Install the remote assembly onto the handlebar. Position the remote assembly so that
the bleed screw is at the highest point on the remote. Use a T25 TORX to tighten the
remote clamp bolt just enough to prevent the remote assembly from rotating on the
handlebar.
BleeD THe ReMOTe AsseMBly
At this point air may have entered the remote assembly. The
next section covers steps for bleeding the remote assembly,
indicated by this icon.
BleeD THe ReMOTe sysTeM
At this point air is in the remote hose, and may have entered
the remote assembly and seatpost. The next section covers
steps for bleeding the remote system, indicated by this icon.
Copyright © 2011 SRAM, LLC
HOse sHORTeNiNg/ReplAceMeNT
English
11