SRAM Rock Shox Reverb Bleed Kit Manual Del Usuario página 7

Reverb Bleed Kit User Manual
3 pRepARe THe ReMOTe
Orient the bike so that the remote is higher than the top of the saddle.
Use a T25 TORX
from the handlebar.
Place an oil pan on the floor directly beneath the remote.
4 ReMOve THe HOse fROM THe ReMOTe
Hold the hose firmly and turn the remote assembly
counter-clockwise to unthread it from the hose.
Use a 6 mm open end wrench to hold the hose
barb stationary and unthread the remote assembly
counter-clockwise from the hose barb by hand.
Allow any hydraulic fluid to drain into the oil pan.
Copyright © 2011 SRAM, LLC
HOse sHORTeNiNg/ReplAceMeNT
® to remove the remote clamp bolt, then remove the remote assembly
English
7