SRAM Rock Shox Reverb Bleed Kit Manual Del Usuario página 13

Reverb Bleed Kit User Manual
3 pRepARe THe ReMOTe
Orient the bike so that the remote is higher than the top of the saddle.
Use a T25 TORX® to loosen the remote clamp bolt then rotate the remote so that
the bleed screw is at the highest point on the remote. Re-tighten the clamp bolt just
enough to prevent the remote assembly from rotating on the handlebar.
Place an oil pan on the floor directly beneath the remote.
Use a T10 TORX to remove both the seatpost and remote assembly bleed screws. Set
the bleed screws aside.
4 pRepARe THe seATpOsT
Wrap a lint-free rag around the seatpost.
Use a T10 TORX to remove both the seatpost and remote assembly bleed screws.
Set the bleed screws aside.
Note the difference in shape between the two bleed screws so you don't confuse
them later. The seatpost bleed screw has a flat base and o-ring, while the remote
assembly bleed screw has a pointed base.
Copyright © 2011 SRAM, LLC
BleeD pROceDURes
English
13