Operating Instructions - Corghi ICL IW Manual De Uso

OPERATING INSTRUCTIONS

a) Check to make sure that oil reaches the sight level glass (2 fig.10) on each head (1 fig.10).
In order to top up, remove the upper panel (3 fig.10).
b) Switch the machine on by means of the master switch (4 fig.10).
c) Set the required working speed using the keypad provided on the intelli-wind (5 fig.10)
after the cross-over angle (1 or 2) has been selected (refer to the intelli-wind manual for
further information).
Depending on the type of yarn, winding can be carried out with cross-over angle 1 (16°)
or 2 (13°).
Each head has a lever (8 fig.12) for setting this angle.
The cross-over angle should only be changed with the machine running. Normally cross-
over 1 (16°) is used with thin or slippery yarn.
The speed is expressed in metres per minute and can be adjusted using the intelli-wind (for
more information, refer to the relevant manual).
To ensure even cones, never make adjustments (speed, cross-over angle, yarn braking,
waxing, direction of rotation, threading) while cones are being produced.
Do not make the cones too soft; as their weight forces them down, they may interfere with
the yarn guide (1 fig.7), thereby breaking the yarn or bending the yarn guide out of shape.
ICL IW - ICL 8" IW operator's manual
Danger warning decals
During all working procedures keep well away from the lever and
reel area of operation.
During all working procedures, keep hands far away from the yarn
guide and roller to prevent crushing accidents.
During all working procedures keep hands well away from the
feeder in order to avoid abrasions.
Starting the machine
Cross-over angle
Running speed
General advice
GB
33