Scrapping - Corghi ICL IW Manual De Uso

WARNING
Before proceeding with any adjustment or maintenance work, disconnect the machine
from pneumatic and electric power supply, and check that all the moving parts are
locked in place.
WARNING
Do not remove or make changes to any part of this machine (only the assistance service
may do this).
- The regulator/lubricator filter is equipped with a semi-automatic condensate water drain
device. This device is automatically activated whenever pneumatic supply to the
machine is cut off. Drain manually when the level of condensate is too high.
- From time to time, lubricate the spindle arm on the rotation axis.
- On a regular basis, when the machine is at a standstill, remove the back panel and
remove the fluff that has collected there. Be careful not to pull out the electric wires. Do
not use compressed air to clean the machine, since this will spread the yarn fluff on the
mechanical moving parts and the electronic components.
- Keep the oil level under control. If it has to be topped up, add only CORGHI Komol 220°
oil or an equivalent (refer to the chart on the machine). Before adding oil, clean off all the
fluff from inside the head.
WARNING
Keep the work area clean
Do not clean the machine with compressed air or jets of water.
When cleaning the area take steps to avoid raising dust as far as possible
If the machine is to be scrapped, first separate the electrical, electronic, plastic and ferrous
parts.
Then dispose of them separately as prescribed by law.
38

SCRAPPING

ICL IW - ICL 8" IW operator's manual