Corghi EM9980 Manual De Uso página 45

Wheel guard and related
support mounting procedure
- Install the bush (A, fig. 7) on the pivot (B, fig.
7). While doing this, ensure that the groove on
the pivot is aligned with the pin in the bush;
B A
- Block the bush on the pin using the M12 screw
(A, fig.7a) supplied with the machine.
- Block the connecting rod (B, fig. 7a) to the
machine casing using the special M10 screw
(C, fig.7a) supplied with the machine.
- fix the metal pipe (A, fig.7b) to the pin (B, fig.7b)
using the two M10 screws (C, fig.7b) supplied
with the machine.
EM9980 - Operator's manual
7
- Insert the metal tube (D, fig.8) into the two
plastic guard front holes (C, fig.8);
- Fasten the guard to the rear of the pipe, snap
fitting into the relative seat (E, fig. 8);
- Lock the guard by tightening the screw F (fig.8).
After assembling the machine, position it in the
selected place and make sure that the spaces
surrounding it are at least equal to the ones
indicated in Fig. 9
7a
7b
8
UK
45