Switching On The Machine - Corghi EM9980 Manual De Uso

be used exclusively to measure the extent and
position of car wheel unbalances, within the limits
specified in the Technical specification section.
Furthermore, models equipped with motors must
be provided with a suitable guard, fitted with a
safety device, which must be lowered during the
spin operation.
WARNING
Any use of the machine other than the de-
scribed use is to be considered as improper
and unreasonable.
CAUTION
Do not start the machine without the wheel
locking equipment.
WARNING
Do not use the machine without the guard and
do not tamper with the safety device.
CAUTION
Do not clean or wash the wheels mounted on the
machine with compressed air or jets of water.
WARNING
It is advisable to use only original tools for
working.
WARNING
Get to know your machine: The best way to
prevent accidents and obtain top performance
from the machine is to ensure that all operators
know how the machine works.
Learn the set up of all controls and their func-
tions. Accurately check for correct functioning
of every machine control device. To prevent
accidents and personal injury, all the equipment
must be correctly installed, correctly operated
and correctly serviced.
50
SWITCHING ON THE
MACHINE
Connect the power supply cable (A, Fig. 11a)
supplied with the machine from the external
electrical panel located on the rear side of the
wheel balancer body to the mains.
A
Turn on the machine using the switch located on
the left-hand side of the body (B, fig.11b).
B
Note: if the image is not centred on the LCD
monitor, adjust it using the controls located on
the front part of the monitor. For further informa-
tion on the adjustment procedure, refer to the
monitor manual provided, which can be found
inside the packaging.
EM9980 - Operator's manual
11a
11b